Dropped $340 on a Haimer 3D taster and I'd do it again tomorrow

Everyone on the shop floor told me to keep sweeping parts in with an edge finder and save the cash, but that thing cut my setup time on a 6 hole fixture from 25 minutes down to 7. Yeah it's a lot for a spinning pointy thing, but the first time it caught a vise jaw I was about to plow into, it paid for itself. Curious what you guys actually think is worth the money in the box, because most of my tool buys are regrets.

0 comments

Log in to join the discussion

Log In

0 Comments

No comments yet

Be the first to share your thoughts on this discussion.